Antenna
|
|
Antennas should be selected considering the desired transmit distance, line-of-sight, RF cable length, and height
of transmission. Each of these parameters should be evaluated in selecting the right antenna for your application. |
|
|
- Used in applications where signal strength is important in all directions from the antenna
- A ground independent half wave dipole suitable for 900MHz products
- Slimline, lightweight antenna that is easily mounted
- Most common antenna used in applications within industrial plants or factories
- 15 feet / 5 meters of RG58 Cellfoil coaxial cable already terminated with a crimped SMA male connector
- Compact antenna made for vertical mounting
|
 |
- The simplest antenna which needs an external reference plane to efficiently radiate power
- Designed for short range use only
- Suitable for internal or external mounting
- May be used on vehicles with a suitable bracket (not supplied) or when mounted in the panel work
|
 |
|
|
- Performs similarly to dipole antennas, but concentrates effective power more in the horizontal plane than vertical planes
- Requires two mounting brackets (ordered separately) to hold the antenna in position. The bracket assemblies consist of 1 x U-Bolt 3 x
D-plates with nuts and washers in each set. The brackets are zinc plated mild steel.
- For Brackets see ANT BR COL KIT
|
 |
- The SG900EL collinear antenna may be used for external or internal mounting.
- Designed for use with the Crouse-Hinds series range of telemetry products the SG900EL meets specific radio conditions for these products.
- The SG900EL is a slim, lightweight antenna that is easily mounted.
|
 |
|
|
- The D1 NW ANT 1 900 antennas are designed for use in “Hazardous-Classified” and Industrial- Hardened applications.
- The antennas are omni-directional with 2.0 dBi gain and designed for flexible mounting on a variety of explosion proof housings (with a ¾” NPT pipe thread).
- The mounting base is made of heavy nickel-plated brass with an integrated TNC coaxial connector for ease of installation.
- The radome is optimized for rugged industrial applications while maintaining maximum radio frequency transmission and reception efficiency.
- The antenna may be mounted up to 18” away from the enclosure within a hazardous location without an additional seal.
|
 |
- The WH900 SMA whip antenna is made for use with the D2 W DEMO 900 demonstration sets. This antenna is small measuring only 3.5”or 90mm in length.
- The WH900 SMA is designed for internal use only. It may be connected directly to the Crouse-Hinds modules.
- It has been selected for its easy use with the demonstration sets.
|
 |
Yagi Antenna
YU6 900
YU16 900
|
- Focuses power in a forward direction for longer range applications
- Higher gain antennas direct power into a tighter beam
- Requires a single mounting bracket (ordered separately).
The bracket assembly consists of 1 x U-Bolt 1 x D-Plate with nuts and washers.
The brackets are zinc plated mild steel.
- For Brackets see ANT BR YAGI KIT
|
 |
| |
| |
| |
